On the gateway (ATT Fiber router), you will likely have a 192.168.1.254 address. The idea is better drawn out as having a gateway (ATT) passing traffic to the router (your router with DD-WRT) and your router being the point where most of your home network devices will connect to. Information is a bit scattered around, but unless you are a network engineer (which I am not) you are not going to have a fun time trying to configure a cascaded router. You should not have to use cascaded router unless you have bought a public IP space which is why you will get the error involving WAN wide subnet when you try to enter in .x with a /24 subnet into the cascaded router boxes.* Isn't convention to use it as a private ip. *Post has been modified to exclude use of .x ip since it I installed the new RC6.1 firmware but the problem remain the same.DISCLAIMER: Expressed views on this blog are my own. Last edited by drpepperONE on Sun 17:28 edited 1 time in total I saw there were changes in SVN regarding MAC's. Last edited by drpepperONE on Sun 17:29 edited 1 time in total I remeber that when I installed the open-wrt on the linksys devices by default open-wrt changed the default mac with one that was always the same for all. Is there some dd-wrt developper that can help me? I believe the atheros calibration and mac addresses are stored in an area marked off as not accessible by the bootloader.īut I think that ther's must be a way to change the default mac address, it's not possibile that thers'not. Try hex editing the bootloader (VERY VERY CAREFULLY!).
Is there any Redboot command to modify the mac address? With the bdshow command it display the origial mac. I tried to change de original default macaddress in Redboot, but i dont saw anithing to do it. to see if I'll able to go in telnet in redboot. I'll try with finally dd-wrt installation. Normaly it works in installation/flashing phase, after the reboot the first 10 second the fon dd-wrt listen on special tcp port. Last edited by drpepperONE on Sun 17:27 edited 1 time in totalīut i'm not sure that in dd-wrt installed it works. I guess if the bootloader is on a partition, you probably will be able to retrieve its contents using a dd command, modify the contents, then use the dd command to upload to the partition to see if the MAC Addresses have changed. Last edited by drpepperONE on Sun 17:26 edited 1 time in total
#Dd wrt change router mac address code
You think ther's not a way to change it in non jtag mode?įor example uploading different code or using a flashing telnet mode RedBoot with fis ? Last edited by drpepperONE on Sun 17:26 edited 3 times in total I saw in the nvram settings these variables: Infact if i check the device value it's setted to original:Ĭat /sys/devices/virtual/net/eth0/addressĬat /sys/devices/virtual/net/ath0/addressįrom web i setted the starup script command with nvram but nevere changed. TX packets:18518 errors:1524 dropped:0 overruns:0 carrier:0 Wifi0 Link encap:Ethernet HWaddr ORIGINAL TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 RX packets:0 errors:0 dropped:0 overruns:0 frame:0 UP LOOPBACK RUNNING MULTICAST MTU:16436 Metric:1 TX packets:14092 errors:0 dropped:0 overruns:0 carrier:0 RX packets:3517 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
TX packets:2610 errors:0 dropped:0 overruns:0 carrier:0 RX packets:17596 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING ALLMULTI MULTICAST MTU:1500 Metric:1 TX packets:11764 errors:0 dropped:0 overruns:0 carrier:0 RX packets:14066 errors:0 dropped:0 overruns:0 frame:0 UP BROADCAST RUNNING MULTICAST MTU:2290 Metric:1 It seems that the default wirless mac it's write into the kernel or in hadcoded way. When I go in to web interface after reboot it seems good:īut if i try to connect with a wirelss client the wirless mac it's always the original default. I successfully installed the last dd-wrt release on Fonera but now I'm not able to change the defaults mac addresses.
#Dd wrt change router mac address how to
Posted: Sun 20:17 Post subject: How to change wireless mac addresses of Fonera?
0 kommentar(er)
